SUPER MICRO Computer AOC-LPZCR1, AOC-SOZCR1 specification

AOC-LPZCR1/AOC-SOZCR1 Manual

3.Once the disk drive is selected, press <Enter>. The Adaptec RAID Utility starts re-scanning the selected drive, and a screen will display as below:

(*Note: Please refer to the following section for SAS and SATA Disk Utilities.)

3-26

Image 42

SUPER MICRO Computer AOC-LPZCR1, AOC-SOZCR1 manual

Contents

Super AOC-LPZCR1/AOC-SOZCR1 Users Guide Table of Contents Introduction AOC-SOZCR1 Series the Terminator Socket Dimm ZCR Card Management support Key RAID FeaturesOperating Systems supported AOC-LPZCR1 Series -Low Proﬁle Skyhawk ZCR RAID Card Headquarters EuropeAsia-Paciﬁc Chapter Technical Speciﬁcations and Software Installation AOC-LPZCR1 Card Layout and Jumper Locations Jumper and Connector Descriptions *AOC-LPZCR1 Jumper DescriptionDescription Buzzer Connector Connectors and LED Indicators *AOC-LPZCR1Activity LED Indicator I2C Cable Connection AOC-SOZCR1 Card Layout and Jumper Locations Front view AOC-SOZCR1Rear view AOC-SOZCR1 SMB I 2C Connector and Header Descriptions *AOC-SOZCR1SMB Connector and Pin Deﬁnitions *AOC-SOZCR1 2C cable Connection Intelligent Interface Management SAF-TE See Note 1 below ESD Safety Guidelines General Safety Guidelines For the Windows 32-bit Operating System Creating the Driver Floppy DiskAdding the Driver into an Existing System For the Red Hat/SuSE Operating System Installing the Driver into a New System For the Red Hat Operating SystemFor the SuSE Operating System AOC-LPZCR1/AOC-SOZCR1 Users Guide Conﬁguring Jumper Settings Chapter RAID Conﬁguration Using Adaptecs RAID Conﬁguration Utility SAS, Sata and Scsi settingsTo Use the Adaptec RAID Conﬁguration Utility Using the Array Conﬁguration Utility RAID Conﬁguration Utility Main Menu To Create Arrays Array Conﬁguration Utility Main MenuPage To Manage Arrays To assign properties to the new array To View the properties of Existing Arrays Deleting Arrays Setting a Bootable Array Adding a Hotspare Disk Drive Deleting a Hotspare Disk Drive Initializing Disk Drives To initialize Disk drivesPage Page To Rescan Disk drives Rebuilding Arrays To Rebuild an array To Secure Erase Drives Page Using Adaptecs SCSISelect Utility Using the Controller Conﬁguration Utility Using the Scsi Conﬁguration Utility Page Page Using Adaptecs SATASelect Utility Using the Sata Conﬁguration UtilityTo Use the SATASelect Utility Using Adaptecs Serial Select Utility To Use the SerialSelect Utility Using Physical Conﬁguration Utility Using Disk Utilities To Use Disk Utilities *for Scsi onlyPage To Use Disk Utilities *for Sata and SAS only To Format a Disk Drive To Exit the Adaptec RAID Conﬁguration Utility To Verify Disk Media Chapter Troubleshooting Contacting Supermicros Technical Support