SUPER MICRO Computer AOC-SOZCR1, AOC-LPZCR1 Chapter RAID Configuration, Configuring Jumper Settings

Chapter 3: RAID Confi guration

Chapter 3

RAID Configuration

After all the hardware has been installed in your system, you must fi rst confi gure the Adaptec Embedded RAID Driver before you install the Windows operating system. The necessary drivers are all included on the Supermicro bootable CDs that came with your card.

(*Note: For the Adaptec RAID Confi guration Utility to function properly, you will need to correctly setup the jumper settings of your add-on card fi rst before using the Utility)

Configuring Jumper Settings

To properly confi gure the jumper settings, please follow the table listed below before using the Adaptec RAID Confi guration Utility. For more detailed informa- tion on jumper settings and locations, please refer to Chapter 2.

SATA/SCSI Jumper Settings for the AOC-LPZCR1 (the Low-Profile Card)

AOC-LPZCR1

Jumper/Function	J6	J5	J3	J7
To flash Firmware	On
To enable SATA based on		On
Hercules II
To enable SCSI			On
To Enable SAS				On

Note1: For jumper locations, please refer to

Page 2-1

Note2: For jumper description, please refer to

Page 2-2

SATA/SCSI Jumper Settings for the AOC-SOZCR1 (the Socket Terminator Card)

AOC-SOZCR1

Jumper/Function	J6	J3	J2	J4
To flash Firmware	On
To enable SATA based on		On
Hercules II
To enable SCSI			On
To Enable SAS				On

Note1: For jumper locations, please refer to

Page 2-4

Note2: For jumper description, please refer to

Page 2-5

*Note 1: Refer to the layouts on Page 2-1 and Page 2-4 for jumper locations.

3-1