![](/images/new-backgrounds/1191817/1918175x1.webp)
Chapter 1: Introduction
Table of Contents
Chapter I: Introduction | ||||
| 1.1 | Overview | ||
| 1.2 | Introduction to SATA and SAS | ||
| 1.3 | Product Features | ||
| 1.4 | Contacting Supermicro | ||
| 1.5 | Product Compliance Information | ||
Chapter 2: Technical Specifications and Software Installation | ||||
2.1 | ||||
2.1.1 | ||||
| ||||
| 2.1.2 Jumper and Connector Descriptions | |||
| 2.1.3 Jumpers and LED Indicators | |||
| 2.2 | |||
| 2.2.1 | |||
| 2.2.2 Connector and Header Descriptions | |||
| 2.2.3 SMB Connector and Pin Defi nitions | |||
| 2.3 | Intelligent Interface Management: | ||
| 2.4 | Safety Guidelines | ||
| 2.5 | Installing the Controller Driver | ||
| 2.5.1 Creating the Driver Floppy Disk | |||
| 2.5.2 Adding the Driver into an Existing System | |||
| 2.5.3 Installing the Driver into a New System | |||
Chapter 3: RAID Configuration | ||||
| 3.1 | Using Adaptec's Array Configuration Utility | ||
| 3.2.1 Using Adaptec's SCSISelect Utility | |||
| 3.2.2 Using Adaptec's SATASelect Utility | |||
| 3.2.3 Using Adaptec's Serial_Select Utility | |||
| 3.2.4 Using Physical Confi guration Utility | |||
3.3 Using Disk Utilities | ||||
| 3.3.1 Using Disk Utilities (*for SCSI only) | |||
| 3.3.2 Using Disk Utilities (*for SATA/SAS only) | |||
|
| 3.3.2.1 To Format a Disk Drive | ||
|
| 3.3.2.2 To Verify Disk Media | ||
| 3.3 | To Exit the Adaptec Array Configuration Utility | ||
Chapter 4: Troubleshooting |