SUPER MICRO Computer AOC-SOZCR1, AOC-LPZCR1 instruction

Chapter 3: RAID Conﬁ guration

4.Use the arrow keys to highlight the channel(-the disk drive) you wish to create a new array, and press <Insert>.

(*Note: To de-select any disk, highlight the disk and press <Del>.)

5.The disk drive that you've selected to create a new array will appear in the "Selected Drives" dialogue box as shown below:

6.Once you've selected all the disk drives for new arrays, and all the drives selected have appeared in the "Selected Drives" dialogue box, press <Enter>. Then, a dialogue box showing array properties will display.

3-5

Image 21

SUPER MICRO Computer AOC-SOZCR1, AOC-LPZCR1 manual

Contents

Super AOC-LPZCR1/AOC-SOZCR1 Users Guide Table of Contents AOC-SOZCR1 Series the Terminator Socket Dimm ZCR Card Introduction Operating Systems supported Key RAID FeaturesManagement support AOC-LPZCR1 Series -Low Proﬁle Skyhawk ZCR RAID Card Headquarters EuropeAsia-Paciﬁc AOC-LPZCR1 Card Layout and Jumper Locations Chapter Technical Speciﬁcations and Software Installation Jumper and Connector Descriptions *AOC-LPZCR1 Jumper DescriptionDescription Activity LED Indicator Connectors and LED Indicators *AOC-LPZCR1Buzzer Connector I2C Cable Connection AOC-SOZCR1 Card Layout and Jumper Locations Front view AOC-SOZCR1Rear view AOC-SOZCR1 SMB Connector and Pin Deﬁnitions *AOC-SOZCR1 Connector and Header Descriptions *AOC-SOZCR1SMB I 2C 2C cable Connection See Note 1 below Intelligent Interface Management SAF-TE General Safety Guidelines ESD Safety Guidelines Adding the Driver into an Existing System Creating the Driver Floppy DiskFor the Windows 32-bit Operating System For the Red Hat/SuSE Operating System Installing the Driver into a New System For the Red Hat Operating SystemFor the SuSE Operating System AOC-LPZCR1/AOC-SOZCR1 Users Guide Chapter RAID Conﬁguration Conﬁguring Jumper Settings Using Adaptecs RAID Conﬁguration Utility SAS, Sata and Scsi settingsTo Use the Adaptec RAID Conﬁguration Utility RAID Conﬁguration Utility Main Menu Using the Array Conﬁguration Utility Array Conﬁguration Utility Main Menu To Create ArraysPage To assign properties to the new array To Manage Arrays To View the properties of Existing Arrays Deleting Arrays Setting a Bootable Array Adding a Hotspare Disk Drive Deleting a Hotspare Disk Drive To initialize Disk drives Initializing Disk DrivesPage Page Rebuilding Arrays To Rebuild an array To Rescan Disk drives To Secure Erase Drives Page Using the Controller Conﬁguration Utility Using Adaptecs SCSISelect Utility Using the Scsi Conﬁguration Utility Page Page Using Adaptecs SATASelect Utility Using the Sata Conﬁguration UtilityTo Use the SATASelect Utility To Use the SerialSelect Utility Using Adaptecs Serial Select Utility Using Physical Conﬁguration Utility To Use Disk Utilities *for Scsi only Using Disk UtilitiesPage To Format a Disk Drive To Use Disk Utilities *for Sata and SAS only To Verify Disk Media To Exit the Adaptec RAID Conﬁguration Utility Chapter Troubleshooting Contacting Supermicros Technical Support