Peripheral Equipment

Audio output connector specification:

Connector label

Signal type

Connector (codec)

Audio outputs

Unbalanced

Female RCA/phono, sleeve-ground,centre-signal

 

Output impedance

 

680 ohms

 

 

 

 

 

 

 

Max output level when set

 

 

 

 

to maximum output level

 

 

 

 

PAL

 

0.75 Vpp

 

 

NTSC

 

1.75 Vpp

 

 

Max output level when set

 

 

 

 

to minimum output level

 

 

 

 

PAL

 

0.75 Vpp

 

 

NTSC

 

1.15 Vpp

 

 

 

 

 

 

 

Range, menu adjustable

 

22.5 dB (16 steps of 1.5 dB)

 

 

output gain

 

 

 

Volume control attenuation (audio out 1)

0 to 21 dB + mute (steps of 1.5 dB)

5.1.3Network

Ethernet:

1 x Ethernet (RJ-45 Jack) LAN interface (10/100 Mb) up to 2 Mbps or 2.3 Mbps depending on the bandwidth option installed.

To connect the system to a LAN, use the Ethernet cable provided by TANDBERG (or a standard Ethernet cable).

The cable specification is:

1 ------------

1

2 ------------

2

3 ------------

3

6 ------------

6

If no LAN is available and the codec is connected directly to a computer, use a crossover cable.

The crossover cable specification is:

If such a connection is needed, the systemandthe PC must use staticTCP/IP settings because no DHCP server is controlling the small LAN , which has been created between the computer and the system. When configuring a back-to-back connection between the PC and the system, make sure both static IP addresses exist on the same subnet.

ISDN BRI Interface:

ISDN I.420 (RJ-45 Jack) Basic Rate Interface S/T (2B+D), 128 kbps per ISDN I/F

195

Page 205
Image 205
TANDBERG T2000 MXP user manual Network, Audio output connector specification Connector label, Audio outputs, Ethernet