TANDBERG T2000 MXP user manual Wireless LAN Settings

D1337703_T2000_MXP_User_Manual

4.8.2.4 Wireless LAN Settings

SSID (Service Set Identification)

Example “WLANNETWORK”. Defines a local network id for this wireless region. It must be the same for all end points and the access point. An endpoint will find the access point if the SSID is correct, however if the encryption key is faulty it will not transmit any data.

Community (optional)

Community“ can”be used when connecting to an access point where the SSID is the same. Example Unit2 .

WLAN Mode

AdHoc

Used when not communicating with an access point.

Managed

Used when communication is made through an access point.

Make sure the corresponding settings are programmed into the access point. Press “Restart” from Control Panel in order to activate the settings.

•cards

•Compaq WL110 11 Mbps Wireless LAN

•Lucent Orinoco 11 Mbit/s SILVER

•Lucent Orinoco 11 Mbit/s GOLD

•Cisco Aironet 350 series (AIR-PCM 350 series)

•Enterasys Networks RoamAbout 802.11 DS High Rate Melco Buffalo WLI-PCM-L11GRequired

Recommended• access point

Compaq WL410 base station

Note! The PC card/PCMCIA-card used must comply with the relevant regulations for such cards in the country where it is used. The unit must be supplied by power supply (AC-DC adapter) powerbox SPN-270-12, which complies with the requirements for limited power source according to IEC/EN 60950.

Encryption

Select Encryption if you want to use WEP encryption on your Wireless LAN connection. Increased encryption level will decrease performance.

Use Key:

Select which of the keys shown below you want to use.

182