DVI Specifications, Digital | TANDBERG T2000 MXP specs

Peripheral Equipment

The TANDBERG codec contains a DVI-I plug that can transmit either digital DVI signals or standard analog VGA signals, depending on what type of monitor is connected.

DVI Specifications

TANDBERG DVI-I follows the VESA Monitor Timing Standard v1.08, also knows as Display Monitor Timing (DMT).

	Analog		Horizontal		Vertical		Pixel
			Frequency		frequency		Clock

	800x600 @		46.875kHz		75.00Hz		49.50MHz
	75Hz

	1024x768		48.363kHz		60.004Hz		65.00MHz
	@ 60Hz

	Digital

	800x600 @		46.875kHz		75.00Hz		49.50MHz
	75Hz

	1024x768		48.363kHz		60.004Hz		65.00MHz
	@ 60Hz

DVI-I Video resolution supported in F1 and above

Supported DVI cables:

TANDBERG supports DVI-D Single-Link, DVI-A and DVI-I Single-Link format cables.

DVI-D cables transmit digital T.M.D.S. signals, DVI-A cables transmit analog VGA signals and DVI-I cables can transmit either digital or analog signals.

It is possible to extend existing DVI cables by the use of extension cables. The maximum cable length however, is 5 meters. Going beyond that may result in quality loss.

DVI-I - Combined Analog and Digital Connector Pin Assignments:

Pin

Signal

Pin

Signal

Pin

Signal

Assignment

Assignment

Assignment

1

T.M.D.S.

9

T.M.D.S.

17

T.M.D.S. Data0-

Data2-

Data1-

2

T.M.D.S.

10

T.M.D.S.

18

T.M.D.S. Data0+

Data2+

Data1+

3

T.M.D.S.

11

T.M.D.S.

19

T.M.D.S.

Data2/4 Shield

Data1/3 Shield

Data0/5 Shield

4

T.M.D.S.

12

T.M.D.S.

20

T.M.D.S. Data5-

Data4-

Data3-

5

T.M.D.S.

13

T.M.D.S.

21

T.M.D.S. Data5+

Data4+

Data3+

6

DDC Clock

14

+5V Power

22

T.M.D.S. Clock

Shield

7

DDC Data

15

Ground (return for +5V, HSync and VSync)

23

T.M.D.S. Clock+

8

Analog Vertical Sync

16

Hot Plug Detect

24

T.M.D.S. Clock-

193

Image 203

TANDBERG T2000 MXP DVI Specifications, Analog Horizontal Vertical Pixel Frequency Clock, Digital, Supported DVI cables

Contents

Page Disclaimer Trademarks and Copyright Production of products Environmental IssuesBattery handling Waste handling Equipment Markings Operator Safety SummaryPage Contact us Table of Contents 12.1 151 Page Network IntroductionAudio Quality Video Quality User interfaces MultiSitePresentations Interoperability Codec At a GlanceCamera Monitor Microphone Remote Control Menu Structure Introduction Precautions Installation Mounting Microphone cable Connecting CablesPower cable Monitor cables VGA cable Camera cableIsdn cables LAN cable How to set Hypersound OFF Monitor ConfigurationHow to select PC analog video input Language System ConfigurationGeneral configuration Open the General Settings menu Screen Settings Software Options Network configuration Open the Network menuIsdn configuration LAN configuration If the system does not respond General UseWake up the system Welcome Screen Layout Using the Remote Control See Selfview Arrow keys and OK Cancel keyBack/Cancel button Navigation Local PC Display How to use SelfviewSelfview Auto Layout LayoutPicture in Picture Picture outside Picture Mic Off Volume + Number and Letter keys Touch Tones On-screen Indicators Telephone Menu contains the following items Using the Menu General Use Make a Call Place Video Call Place Telephone Call Add participants during a conference Set up a conference with two or more participantsAdd Call D1337703T2000MXPUserManual Call Settings Streaming Allow Remote Streaming PasswordStreaming Source Answer an incoming call How to answer an incoming callHow to reject an incoming call To end a call How to end a MultiSite callEnd Call Standby To turn on the standby mode manuallyHow to turn off the standby mode Delay Standby for 1 hour Delay Standby for 3 hours Do Not Disturb Following information is available from the Phone Book Phone Book  Call History  My Contacts  Global Contacts Following buttons are available from these folders How to make a call using the call listsCall Log My Contacts How to make a call using My Contacts Following functions are available from My Contacts Add a new contact to My Contacts by Add New Contact New MultiSite Contact How to define a New MultiSite Contact Bandwidth for a MultiSite Contact call Edit Contact How to edit a contact in the Local Phone Book Delete Contact How to delete a contact From Global Contacts the following functions are available How to make a call using Global ContactsGlobal Contacts Up one Level Search How to search in the Global Phone Book Copy Contact to My Contacts There are several ways to control the camera Camera Control Moving the Camera via the menu Moving the camera directly with the remote controlMove Camera Far End Presentation How to use Far End controlFar End Camera Presets Far End Control How to save a new preset directly from the remote control Camera PresetsHow to use preset directly from the remote control How to use presets via the menu Tandberg Tracker How to save presets for the Tandberg Tracker Picture Control Camera Tracking How to use Camera Tracking Presentation Presentation Key Presentation Menu How to change your main video source PC Presenter DVI/XGA Input How to connect a PC to the codec with the DVI/VGA cable PC Soft Presenter and VNC How to configure the VNC Server softwareHow to show PC using the PC Soft Presenter and VNC Dual Stream and Bandwidth Dual Stream DuoVideoTF/H.239 Take New Snapshot How to use snapshot Receiving snapshots How to display snapshotsDisplay Snapshot Conference Services Using an external MCU that supports Chair Control H.243 Using the system’s internal MCU, MultiSiteTF Terminal Names Request Floor and Release Floor How to use Request and Release Floor Advanced Continuous Presence Layout 5+1 Conference Layout Terminal Names Chair Control Assign Floor and Release Floor from Participant View Site and End View Disconnect Participant Terminate Meeting More about MultiSite embedded MCU Control Panel Control Panel contains the features Diagnostics contain Diagnostics Hardware Serial Number System InformationSystem Information contains System Name Cause codes Channel Status Call Status System Selftest View Administrator Settings Alert Tones & Volume Default Call SettingsAudio Settings Inputs Level Settings Leased E1/T1 Settings Advanced Isdn SettingsISDN-PRI Settings Advanced Isdn PRI Settings Streaming Settings SettingsAdvanced H.323 Settings Snmp Settings IP Address Conflict Check External Network warnings ISDN BRI warningsIP network quality warnings ISDN PRI warnings Gatekeeper warnings Text Chat How to use Text Chat Audio Demo Administrator Settings Restart User Guide Administrator Settings contain Administrator Settings General Settings contain General Settings Language System Name identifies the system System Name Off Auto AnswerOn+Mic Off Max Call Length Path Phone Book SettingsPhone Book IP address Incoming Telephone Calls Access CodePermissions Incoming MCU Calls Fallback to Telephony Remote Software Upgrade Screen Settings 113 Wide VGA Monitor FormatNormal XGA 1024x768 60Hz VGA Out QualitySvga 800x600 75Hz VGA output will have 43 aspect ratio on wide screen monitor Following options are available Software Options Menu Settings contain the settings Menu Settings Menu Timeout In Call Welcome Menu Selfview Welcome Picture Logo Balloon Help Display Welcome Text Welcome Text Administrator Password Presentation Settings contain Presentation Settings Presentation Start 2 H.239 EnabledDisabled Call Video Source Presentation Source Snapshot Source Auto-Display Snapshot Off PIP Off means that PIP is not displayed automatically PIP Appearance PIP Placing Display Number VNC SettingsPassword Call Quality Call Quality contains the settings 261 Video Algorithm264 263 Audio Algorithm AAC-LD 128kbps stereo audio Custom Natural Video Max Upstream Rate kbps Motion IVM ResolutionVideo Quality Intelligent Video Management IVM PC Resolutions Native Resolutions Call Type Default Call Settings 221 or 2x64 2x56 Calling BandwidthOverview Restrict 56k Example Using sub-address / extension address / MCU password Audio Audio contains the settings Fixed Mix ModeInputs Mic 1- 2 and Audio inputPage Audio Out Outputs On+NR Tips for improving the echo canceller performanceEcho Control Mic Stereo Input Mode stereo audio Stereo Settings Audio Levelling AGC Alert Speaker Alert Tones and VolumeAlert Volume Video Call Alert Tone and Telephone Alert Tone Video Video contains the settings Fast Camera Tracking ModeSlow MCU Status Line Floor to Full Screen Web Snapshots Split MultiSite Picture ModeVoice Switched Auto Split 162 Video Name Security Security contains the settings Encryption AES Encryption Mode Passwords Network menu contain Network Sub address ISDN-BRI SettingsNumbers Sending Complete Validate Numbers / MSN Multiple Subscriber NumberParallel dial Send Own Numbers LAN Settings contain LAN Settings IP Settings IP Access Password DNS Domain Name DNS Server 2.2 H.323 Settings Gatekeeper IP Address Authentication Mode AutoAuthentication ID / Authentication Password Gatekeeper Discovery Auto CallManager IP CallManager Settings Ports NAT Address Dynamic Static Server Discovery Auto SIP SettingsMode SIP Address User Name Server Address Wireless LAN Settings Key 1 Snmp Settings NTP IP IP Services Quality of Service Diffserv Telephony Diffserv Video Network Profiles Baud Rate, Parity, Databits and Stopbits Data Port Restore Default Settings Peripheral Equipment contains Peripheral Equipment Video Inputs DVI and specificationsInterfaces Video Supported DVI cables DVI SpecificationsAnalog Horizontal Vertical Pixel Frequency Clock Digital Audio Outputs AudioAudio Inputs Ethernet Audio output connector specification Connector labelNetwork Audio outputs Pinout Signal name Direction Pin Number Document Camera How to use a document camera with your system Stereo DVD / VCRDVD/VCR Playback Mono Extra fixed Cameras Additional Cameras Additional Microphones Stereo out Tandberg DnamTandberg Digital Natural Audio Module 202 Stereo Speaker Kit Telephone Add-On Provides a mixed signal between local and far end Dual Monitor XGA Monitors and Projectors Monitor Dpms mode Vesa Display Power ManagementPower savings Recovery time Power state to Intermediate Power state Digital Monitor Power Management Detailed timing description Extended Display Identification Data Edid MAG DJ707 Tested and verified monitors, Edid & Timing Appendices Appendices Appendix Technical Specification Model 3000MXP / 3000NET Model8000MXP, 7000MXP 6000MXP, Maestro 1000MXP Model 990MXP / 990NET880MXP / 880NET MXP 770MXP 550MXP Background Loudspeaker volumeIris control and lighting Walls How to prepare a typical room for videoconferencingLighting Seating Area TablePage To upload this file to the system, follow these steps Administrator Password IP Services Page Custom logos Description of the different files Web Interface How to configure your system for web interface Configuration of Adtran T1 ESF CSU ACE Using CSU adapterConnecting to Adtran T1 ESF CSU ACE Configuration of the system How to call Using Telesync TS-256 SW56/ISDN adapterConnecting Configuring Connecting the system to Isdn using NT1 network adapters Wave II Camera Pinouts and Connectors PRI Remote Control TRC 230 Cisco CallManager registration Layer 4 Ports used in H.323 calls 931Ping Traceroute Function Port Type Using Isdn Using the web interfaceUsing FTP Page Upgrading using FTP Isdn Upgrade Page Declaration of Conformity Page Index Presentation Glossary Accessories drawer See Accessories box Continuous Presence See Split Screen Closed Captioning Text chatPage Page Page Page VHS S-video