Figure 22. The Release Tool Inserted into the Correct Hole on the Left Lower Magazine
Standby Functionality
On the front panel a standby button is available.
To activate Standby mode, press the button for a minimum of 2 seconds. The StorageLibrary will enter a standby mode in a controlled manner. The following takes place before the StorageLibrary goes into standby mode:
1Finish any StorageLibrary activity.
2The power to the tape drives are switched off.
3The display is turned off.
4No StorageLibrary activity is allowed until the standby button is pressed again.
5The green LED on the front will blink with short blinks- long intervals.
6To leave the standby mode, press the standby button for 2 second. The StorageLibrary will then restart and perform a full inventory.
52 | Running the Library |
