Tandberg Data T40 Removing the Magazine from the Unit, Inserting Cartridges into the Magazine

Removing the Magazine from the Unit

The following illustration shows the correct way to remove the magazine from its bay.

Note	You cannot remove the magazine if the unit is password protected or locked by
	host software through a Prevent Medium Removal SCSI command.

When ejecting the magazine it automatically pops out a few inches. With one hand, grip the handle on the outer side of the magazine bezel and hold the other hand under the magazine. Pull the magazine carefully out and keep it in level with the library. If the magazine is filled with cartridges, be aware of the weight of the magazine. Keep one hand underneath the magazine to prevent the back of the magazine to fall down when it leaves the magazine bay. See Figure 18. Removing the Magazine from the Library.

Figure 18. Removing the Magazine from the Library

Inserting Cartridges into the Magazine

When inserting cartridges, the access door of the cartridge must face the magazine slot opening. Push the cartridge carefully into the magazine slot until it locks in place. The rear side of the cartridge with the Write Protect switch and the barcode label must face out. Make sure the cartridges latch properly.

Figure 19. Gently Push the Cartridge into the Magazine Slot

Removing Cartridges from the Magazine

Press the cartridge release tab towards the cartridge until the cartridge is released. The cartridge is spring loaded, so it is important to prevent the cartridge from popping all the way out.

50 Running the Library