Step 3
Take one of the scraper blades and slip it under the hook at the front of the beater. Wrap the blade around the beater following the helix and pushing the blade down onto the helix as you wrap. At the back end of the beater, slip the blade under the hook. Repeat this step for the second scraper blade.
Figure 14
USE EXTREME CAUTION when handling the beater assembly. The scraper blades are very sharp and may cause injury.
Step 4
Holding the beater securely, slide the beater one third of the way into the freezing cylinder. Looking into the freezing cylinder, align the hole at the rear of the beater with the flats on the end of the drive shaft.
Figure 15
Step 5
Slide the beater the remainder of the way into the freezing cylinder and over the end of the drive shaft. The beater should fit snugly, but not so tightly that the beater cannot be turned slightly to engage the drive shaft. If the beater slides in too easily with little or no resistance, there will not be enough force against the beater to hold the blades in place.
Repeat these steps for the other side of the C717.
Freezer Door Assembly
The assembly of the C709 freezer door is different from the C717 freezer door. Please follow the appropriate instructions for your machine.
Model C709 Freezer Door Assembly
Step 1
Place the door gasket into the groove on the back of the freezer door. Slide the front bearing over the baffle rod so the flanged edge is against the door.
DO NOT lubricate the gasket or bearing. (See Figure 16.)
Figure 16
Operating Procedures | 32 | Models C709 & C717 |
|
|
|
