Step 10
Stand the assembled feed tube in the corner of the mix hopper and place the agitator on the agitator housing.
Figure 41
Step 11
Return to the freezer with a small amount of sanitizing solution. Dip the door spout brush into the sanitizing solution and brush clean the door spout and bottom of the draw valve.
Note: To assure sanitary conditions are maintained, brush clean each item for a total of 60 seconds, repeatedly dipping the brush in sanitizing solution.
Repeat these steps for the other side of the C717.
Figure 42
The pin on the inner feed tube should be turned and positioned at the bottom of the notch in the outer feed tube. This will align the holes in the feed tubes and allow mix and air to enter the freezing cylinder.
Step 1
With a pail beneath the door spout(s), open the draw valve. Pour
Step 2
When mix stops bubbling down into the freezing cylinder, install the assembled feed tubes in the mix inlet hole.
Figure 43
Step 3
Select the AUTO symbol .
Step 4
Fill the hopper with fresh mix and place the mix hopper cover in position.
Repeat these steps for the other side of the C717.
140718
Models C709 & C717 | 39 | Operating Procedures |
|
|
|