Step 3
While the solution is flowing into the freezing cylinder, take particular care to
Step 4
Place the power switch in the ON position.
Step 5
Touch the WASH symbol / and allow the sanitizing solution in the freezing cylinder to agitate for five minutes.
Step 6
With a pail beneath the door spout(s), open close the draw valve six times. Then open the draw valve and draw off the sanitizing solution.
Step 7
Touch the WASH symbol / and close the draw valve.
Figure 38
Note: Be sure your hands are clean and sanitized before going on in these instructions.
Step 8
Lubricate the
Figure 39
Step 9
Install the air orifice into the hole in the top of the inner feed tube.
Figure 40
Note: Make sure the hole in the air orifice is clean and is not clogged. If the hole in the air orifice should become clogged, use soap and hot water to clear the hole. Do not enlarge the hole in the air orifice.
130228
Operating Procedures | 38 | Models C709 & C717 |
|
|
|