Taylor Wash Symbol, Auto Symbol, Reset Mechanism, Adjustable Draw Handle, Models C709 & C717

IMPORTANT: Make sure the level of mix in the hopper is below the mix delivery hole in the feed tube. Failure to follow this instruction may result in lower product quality when normal operation is resumed.

To resume normal operation, press the AUTO

symbol . When the unit cycles off, the product in the freezing cylinder will be at serving viscosity. At this time, turn the inner feed tube so the pin fits into the groove of the outer feed tube. Install the air orifice.

Wash Symbol

The WASH symbol (Model C709) or

(Model C717) will illuminate when it is touched. This indicates beater motor operation. The STANDBY or AUTO modes must be cancelled first to activate the Wash mode.

Auto Symbol

The AUTO symbol will illuminate when it is touched. This indicates that the refrigeration system has been activated. In the AUTO mode, the WASH or STANDBY functions are automatically cancelled.

Note: An indicating light and an audible tone will sound whenever a mode of operation has been selected. To cancel any function, touch the key again. The light and the mode of operation will shut off.

Reset Mechanism

The C709 reset button is located in the service panel on the left side of the machine. The C717 reset buttons are located in the rear panel of the machine.

Reset button(s) protect the beater motor(s) from an overload condition. Should an overload occur, the reset mechanism will trip. To properly reset the freezer, place the power switch in the OFF position. Press the reset button firmly. Turn the power switch

to the ON position. Touch the WASH symbol / and observe the freezer's performance.

Note: To clear the fault, refer to page NO TAG.

WARNING: Do not use metal objects to press the reset button. Failure to comply may result in severe personal injury or death.

If the beater motor is turning properly, touch the WASH symbol / to cancel the cycle. Touch the

AUTO symbol to resume normal operation. If the freezer shuts down again, contact your authorized service technician.

Adjustable Draw Handle

These units feature an adjustable draw handle(s) to provide the best portion control, giving a better, consistent quality to your product and controlling costs. The draw handle(s) should be adjusted to provide a flow rate of 5 to 7-1/2 oz. (142 to 213 g.) of product by weight per 10 seconds. To INCREASE the flow rate, turn the screw CLOCKWISE, and COUNTERCLOCKWISE to DECREASE the flow rate.

Figure 9

130819

Models C709 & C717 17 Important: To the Operator