Taylor C709 manual Brush Cleaning, Repeat these steps for the other side of the C717 Step

Brush Cleaning

Step 1

Prepare an approved 100 PPM cleaning solution (examples: 2-1/2 gal. [9.5 liters] of Kay-5R or 2 gal. [7.6 liters] of Stera-SheenR). USE WARM WATER AND FOLLOW THE MANUFACTURER'S SPECIFICATIONS. Make sure all brushes provided with the freezer are available for brush cleaning.

Step 2

Remove all o-rings.

Step 3

Thoroughly brush clean all disassembled parts in the cleaning solution, making sure all lubricant and mix film is removed. Be sure to brush all surfaces and holes, especially the draw valve hole in the freezer door.

Step 4

Rinse all parts with clean, warm water. Place the parts on a clean, dry surface to air dry overnight.

Step 5

Return to the freezer with a small amount of cleaning solution. Using the black brush, clean the rear shell bearing at the back of the freezing cylinder.

Figure 53

Repeat these steps for the other side of the C717.

Step 6

Wipe all exterior surfaces of the freezer with a clean, sanitized towel.

080227

Models C709 & C717 45 Operating Procedures