Taylor manual Draining Product From The Freezing Cylinder, Rinsing, Step, Models C709 & C717

Draining Product From The Freezing Cylinder

Step 1

Press the AUTO symbol , cancelling compressor and beater motor operation.

Step 2

Remove the hopper cover, the agitator paddle, and the assembled feed tube. Take these parts to the sink for cleaning.

Step 3

With a pail beneath the door spout(s), touch the

WASH symbol / and open the draw valve.

Figure 49

Drain the product from the freezing cylinder and the mix hopper and properly dispose of the mix.

Step 4

When the flow of product stops, touch the WASH

symbol / , cancelling the Wash mode. Close the draw valve.

Repeat these steps for the other side of the C717.

Rinsing

Step 1

Pour two gallons (7.6 liters) of cool, clean water into the mix hopper. With the white hopper brush, scrub the mix hopper, mix level sensing probes and the outside of the agitator drive shaft housing. Using the double ended brush, brush clean the mix inlet hole.

Figure 50

Note: Do not brush clean the mix inlet hole while the machine is in the Wash mode.

Step 2

With a pail beneath the door spout(s), touch the

WASH symbol / .

Figure 51

130228

Models C709 & C717 43 Operating Procedures