Technicolor - Thomson 570i manual First-time Wireless Client Connectivity, Association

1 SpeedTouch™570 Installation

1.3.1. First-time Wireless Client Connectivity

Initial SpeedTouch™570 When the SpeedTouch™570 leaves the factory and after every Push-to-Defaults, the wireless configuration SpeedTouch™570 wireless configuration returns to its initial default settings.

These settings are as follows:

•The SSID is as printed on the identification label located on the bottom of your SpeedTouch™570 .

•The DSSS radio channel number is set to “automatic”.

•The 'Registration' button is activated.

•The Access Control List is empty and locked.

•WEP encryption is disabled.

Preconditions for a successful first-time WLAN client registration

Make sure that:

•The SpeedTouch™570 is powered on and ready for service.

•The SpeedTouch™570 is in its default configuration.

If needed, perform a push-to-defaults via its default button.

•The WLAN client adapter is installed on your computer.

By default the WLAN client adapter’s IP configuration is set to dynamically obtain its IP configuration (DHCP).

•The WLAN client is correctly configured for the default SpeedTouch™570 SSID, hence associated to the SpeedTouch™570 WLAN. Depending on your WLAN client a wireless icon may become green or a message similar to the following may pop up: “Successfully joined Wireless network SpeedTouch012345".

Note Some WLAN clients do not automatically join a WLAN. If so, follow the instructions for the WLAN client software to initiate the association.

Registering the first Proceed as follows:

WLAN client

Step		Action
1	Make sure that all preconditions mentioned above are met.
2	Push the red Registration button on the SpeedTouch™570 back panel.
3	Make sure the WLAN client is correctly associated again to the Speed-
	Touch™570 WLAN. Depending on your WLAN client adapter a wireless icon
	may become green or a message similar to the following may pop up:
	“Successfully joined Wireless network SpeedTouch012345".
	Note	Some WLAN clients do not automatically join a WLAN. If so,
		follow the instructions for the WLAN client software to initiate
		the association.
4	As a result the WLAN client is associated to the default SpeedTouch™570
	Wireless environment and registered to the Access Control List.

3EC 17766 BAAA TCZZA Ed. 01 15