Technicolor - Thomson 608 WL Edit SpeedTouch service properties, Chapter, In Service properties

Chapter 5

Expert Configuration

Edit SpeedTouch™ service properties

116

Editing SpeedTouch™ services might be useful in cases where you want to hide/ protect the service by deviation from the typical service settings or restricting access from/to interfaces. However;

!Do not edit SpeedTouch™ system services unless specifically needed.

To edit a SpeedTouch™ system service:

1Select the service.

2In Service properties:

Select or clear Service enabled to respectively enable or disable the service.

Depending on the service, either:

Select a Source IP interface.

Type a new Internal TCP/UDP port.

3In External TCP/UDP Port, optionally:

Clear existing External TCP/UDP ports, if applicable.

Type the port number of an additional external TCP/UDP port to add.

4In Allow service via (Interface), optionally: Clear existing interfaces, if applicable. Type the name of the additional interface.

5In Accept service from (Remote IP), optionally:

Clear existing remote IP addresses, if applicable.

Type the IP address of the specific remote IP host.

6Click Apply to apply your changes to the SpeedTouch™ service.

You must repeat the procedure for each individual External TCP/UDP port, interface, or remote IP address you want to add.

E-DOC-CTC-20050429-0104 v1.0