Technicolor - Thomson 605, 620, 608 Reset to Factory Defaults, Resetting your SpeedTouch, Chapter

Chapter 8

Troubleshooting

8.3 Reset to Factory Defaults

Resetting your SpeedTouch™

You might consider a reset to factory defaults as described below.

!	Be aware that a reset to factory defaults will revoke all configurational
	changes you made to the SpeedTouch™.

You can choose between:

Hardware reset

Software reset

A reset to factory default settings deletes the configuration profile settings. Therefore, after the reset, a reconfiguration of your SpeedTouch™ will be needed.

Also your WLAN clients will have to be re-associated, as described in “2.2.2 Connecting First-time Wireless Clients” on page 24.

Hardware reset Proceed as follows:

1Make sure the SpeedTouch™ is powered on.

2Use a pen or an unfolded paperclip to push the recessed reset button on the back panel. The reset button is marked with a red circle. Keep it pushed until the power LED lights red - this will take about 7 seconds.

ON

15VAC OFF

Console

Reset Asso-

ciation

1 2

ISDN

3 4

3Release the reset button.

4The SpeedTouch™ restarts.

!	Your system administrator may have disabled the physical reset button of
	the SpeedTouch™. In this case, a hardware reset to defaults is not possible.

E-DOC-CTC-20050429-0104 v1.0 199