Technicolor - Thomson 620, 605 1.1.2, Software Features, ADSL compliance, ATM features, Chapter

Chapter 1

Your SpeedTouch™

1.1.2	Software Features
ADSL compliance
	If POTS in overlay: G. handshake, Full Rate ADSL, G.dmt, G.lite (splitterless
	ADSL), ADSL2, RE-ADSL and ADSL2+
	If ISDN in overlay: G.handshake, G.dmt, ADSL2, RE-ADSL and ADSL2+
ATM features
	Up to 16 simultaneous PVCs, allowing multiple simultaneous destinations
	ATM QoS per PVC: CBR, VBR-rt, VBR-nrt, UBR
	Service monitoring through ITU-T I.620 F4/F5 loopback, alarms (AIS / RDI) and
	continuity checks
	ATM PING command (loopback cells) and continuity check generator mode
	RFC 1483 / 2684 multiprotocol encapsulation over AAL5 / ATM: both LLC /
	SNAP and VC-based multiplexing supported
Bridging features
	Multiport self-learning transparent bridge per IEEE 802.1D for LAN interconnect
	Remote bridge ports are isolated from each other
	Pre-defined bridge filters to WAN (no filter, no CPE-to-WAN broadcast, PPPoE
	only) and to LAN (no filter, multicast filter)
Routing features
	Multi-port (up to 16 PVCs) router
	Static routing, automatic routes (PPP, LAN)
	IP address multi-homing
	Packet classified routing:
	Label classification of packet streams based on source and destination IP
	address, source and destination port, type of service / diffserv bits,
	protocol, source interface
	Forwarding of packet streams based on the label classification
	Type of service / DSCP marking based on the label classification
	IGMPv1/v2/v3 forwarding
	TCP (RFC793), UDP (RFC768), ICMP (RFC792), IPv4 router (RFC1812)
	Dynamic routing RIPv1 (RFC 1058) and RIPv2 (RFC 1723 / 2453), configurable
	per interface

6 E-DOC-CTC-20050429-0104 v1.0