2. Remove the left-hand lug from the CCU DT500CCUlocated on the right by unscrewing both the attaching screws.
3. Remove the CCU DT500 power supply located to the left by unscrewing the 3 attaching screws.
4. Place the front cover against the left-hand side of the CCU DT500 located to the right (only one position correct).CCU
located to the left by unscrewing
8. Place the accessory in the accessory rack (accessory attachment is to be adapted according to its type and brand).
9. Place the CCU DT500 + accessory assembly in the 19" rack at the location required and attach it using both lugs.
2.1.2 - Fitting of two Channel Control Units in the rack
EQUIPMENT AND TOOLS REQUIRED:
• Reference kit BDT05700AA.
• One screwdriver.CCU
1. Remove the right-hand lug from the CCU DT500 both the attaching screws.

128

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Chapter 2 - Installation

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Installation of ccu in rack

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

THOMSON TTV1707 / CCU DT500

B1707M00LD

User manual

September 2000

Page 128
Image 128
Technicolor - Thomson CCU DT 500, CAMERA TTV 1707 manuel dutilisation 128