Technicolor - Thomson CAMERA TTV 1707 Ccu, Installation 127 Installation of ccu in rack

Chapter 2 - Installation		127
Installation of ccu in rack
	CCU

6. Attach the LH lug of the CCU DT500 (removed in 1) to the left of the accessory rack.

7.Place the accessory in the accessory rack (accessoryCCUattachment is to be adapted according to its type and brand).

8.Place the CCU DT500 + accessory in the 19" rack at the desired location and attach by means of the two lugs.

2.1.1.2 - Fitting of accessory rack to the right of the Channel Control Unit

The principle is identical to the previous procedure, but the six 4 mm dia. screws joining the two assemblies are to be fitted from inside the CCU DT500. This implies that the CCU power supply unit must be removed.

1.Remove the right-hand lug from the CCU DT500 by unscrewing both attaching screws.

2.Couple the accessory rack to the RH side of the CCU DT500, with the lugs located at the front of the CCU DT500.

3.Remove the power supply unit by unscrewing the 3 attaching screws.

4.Tighten the six 4 mm dia. screws using the screwdriver from inside the CCU DT500 (power supply unit removed) to attach the accessory rack to the CCU DT500.

5.Place the front cover against the right-hand edge of the CCU DT500 (only one position correct).

6.Tighten both 3 mm dia. screws using the screwdriver from the inside of the CCU DT500 to attach the front cover.

7.Attach the RH lug of the CCU DT500 (removed in step 1) to the right of the accessory rack.

B1707M00LD	THOMSON TTV1707 / CCU DT500
September 2000	User manual