Toro 3000D manual Height of Cut Adjustment, Inch Cutting Units Groundsmaster 3000/3000-D

Height of Cut Adjustment

The height–of–cut is adjustable from 1 to 5 inches (25 to 127 mm) in 1/2 inch (13 mm) increments.

1.Start engine and raise cutting unit. Stop engine after cutting unit is raised.

2.Remove front snapper pins from castor arms and slide castor wheel assembly up or down.

3.Insert snapper pin into castor arm and through groove in castor shaft to get desired height–of–cut.

4.Remove hair pin cotter and clevis pin securing height–of–cut chain to rear of deck.

5.Mount height–of–cut chain to desired height–of–cut hole with clevis pin and hair pin cotter.

6.When using 1 inch (25 mm) height–of–cut, move skids, anti–scalp rollers, and wings wheels to the high­ est holes.

1

Figure 2

1. Snapper Pin

Figure 3

1

Figure 4

1. Height–of–Cut chain

Figure 5

84 inch Cutting Units Page 9 – 4 Groundsmaster 3000/3000–D