Toro 3000D Wheel and Tires, Lubrication, Check Tire Pressure, 5 21 Rev. a Hydraulic System

Service and Repairs

Wheel and Tires

Check Tire Pressure

The tires are over–inflated for shipping. Therefore, re­ lease some of the air to reduce the pressure. Correct air pressure in the front and rear tires is 15 psi (1 Bar).

IMPORTANT: Maintain even pressure in all tires to as­ sure a good quality–of–cut and proper machine perfor­ mance. DO NOT UNDER INFLATE.

Check Wheel Nut Torque

WARNING

Torque wheel nuts to 70–80 ft–lb (10–11 Kgm) after 1-4 hours of operation and again after 10 hours of operation and every 200 hours thereafter. Failure to maintain proper torque could result in failure or loss of wheel and may result in personal injury.

Lubrication

The machine has grease fittings that must be lubricated regularly with No. 2 General Purpose Lithium Base Grease. If machine is operated under normal condi­ tions, lubricate all bearings and bushings after every 50 hours of operation or immediately after every washing.

Intermediate Drive Shaft (3) (Fig. 25), 4WD Rear DrIve Shaft (3) (Fig.26), Pedal Pivots (5), Traction pedal (In square tube under floor plate) (1) (Fig. 27) and Lift arm pivot (2) (Fig. 28).

Figure 26

Figure 25 Figure 27

		Figure 28
Groundsmaster 3000/3000–D	Page 5 – 21 Rev. A	Hydraulic System

Hydraulic System and Transaxle