Toro 3000D manual Lubrication, Traction Unit

Lubrication

Traction Unit

CAUTION

Before servicing or making adjustments to the machine, stop engine and remove key from the switch.

The machine has grease fittings that must be lubricated regularly with No. 2 General Purpose Lithium Base Grease. If machine is operated under normal condi- tions, lubricate all bearings and bushings after every 50 hours of operation or immediately after every washing.

Product Records and Maintenance

The grease fitting locations and quantities are:

Figure 3

2 Wheel Drive Models only–Steering cylinder ball joint, Rear axle tie rod (2), Rear axle pivot (1) Rear Spindle Shafts (2) (Fig. 1).

4 Wheel Drive Models only–Steering cylinder ball joints, Rear axle tie rod (2), Rear axle pivot (1), Double Cardan joints (2 ea. side) (Fig. 2) and Rear DrIve Shaft

(3) (Fig.3)

All Models–Intermediate Drive Shaft (3) (Fig. 4); Pedal Pivots (5), Traction pedal (In square tube under floor plate) (1) (Fig. 5) and Lift arm pivot (2) (Fig. 6).

Figure 4

Figure 1

Figure 5

Figure 2		Figure 6
Groundsmaster 3000/3000–D	Page 2 – 5	Product Records and Maintenance