Toro 3000D manual Height of Cut Adjustment

Height of Cut Adjustment

The height–of–cut is adjustable from 1 to 5 inches (25 to 127 mm) in 1/2 inch (13 mm) increments.

1.Start engine and raise cutting. Stop engine after cut­ ting unit is raised.

2.Remove front snapper pins from castor arms and slide castor wheel assembly up or down.

3.Insert snapper pin into castor arm and through groove in castor shaft to get desired height–of–cut.

4.Remove hair pin cotter and clevis pin securing height–of–cut chain to rear of deck.

5.Mount height–of–cut chain to desired height–of–cut hole with clevis pin and hair pin cotter.

6.When using 1 inch (25 mm) height–of–cut, move skids and gage wheels to the highest holes.

1

Figure 4

1. Snapper Pin

Figure 5

1

Figure 6

1. Height–of–Cut chain

Figure 7

72 inch Cutting Units Page 11 – 4 Groundsmaster 3000/3000–D