STEP 2: Slide Side Plates in along C-Channel base.
2.1Facing the front of the UPS, slide a side kick plate with the smooth side facing out down along the left base C- channel skid until it is protruding about one inch in front of the UPS. See Figure
2.2Repeat for the right
STEP 3: Align the F/B Plate with the UPS front.
Place a F/B kick plate on the floor as in Step
STEP 4: Insert Side Plate tabs into F/B Plate slots.
Insert the side plate tabs into the F/B kick plate slots on the floor in front of the UPS, and then slide the right edge out until the pair of front slots at each end of the plate are visible. See Figure
4.1Carefully slide the F/B kick plate forward until the Side plate tabs are inserted in the F/B kick plate slots. (NOTE
- This is a snug fit.)
4.2Slide the right side of the F/B kick plate forward to engage the tabs of the right Side kick plate.
4.3Slide the F/B kick plate forward until the left and right Side kick plate magnetic latches make contact with the F/B kick plate.
4.4Slide the F/B kick plate back until it make contact with both the
STEP 5: Attach the rear F/B Plate to the back of the UPS
Repeat Step 4 for the F/B kick plate at the rear of the UPS.
64 | 4300 Series Ancillary Cabinets Installation and Operation Manual |