Installation
Step 2: Program Strata
Step 2: Program Strata
Strata CTX Systems
To the Strata CTX processor, the Stratagy IVP8 functions as an analog card (RSTU). Although there are some special program settings required for the Stratagy IVP8 (e.g., DSS/BLF feature), the Strata CTX should be programmed just as it would for any external voice mail system that is to be connected to it.
Important! The Strata CTX may need to be reset to initialize some Strata programming assignments. It is important that you make all such assignments before installing the Stratagy IVP8.
1.Stratagy is compatible with all Strata CTXs. Strata CTX needs to recognize Stratagy’s DTMF signaling. An ARCS card must be installed in the Strata CTX100 for this DTMF signaling. Strata CTX670 allows four DTMF circuits in its default configuration.
•Install and program an ARCS card in the Strata CTX100. When installed, the ARCS card by default allows four circuits. Additional licenses may be required, depending upon the Strata CTX configuration and applications.
•Program slot in Strata CTX before installing the Stratagy. Refer to Strata CTX Programming Manual for details.
2.Do you want to activate the DSS/Busy Lamp feature? PDKU/BDKU cards must be installed that is programmed for a DSS Console.
•Install and program the PDKU/BDKU in the Strata CTX.
•Refer to the Strata CTX Programming Manual for DSS programming.
Note See “Busy Station Identification” on page 27 for required settings on Stratagy IVP8.
3.Are you going to have SMDI? SMDI is required for the Call Record feature with Stratagy Release 3.3/IVP8. A BSIS card must be located close to the Stratagy.
•Install and program serial card BSIS in the Strata CTX. Refer to the Strata CTX Programming Manual.
•A serial cable must be installed between the BSIS card and the Stratagy. Toshiba’s
•Stratagy’s serial Port 1 is reserved for SMDI communication.
10 | Stratagy IVP8 Installation Guide 01/02 |
