Installation
Step 3: Shut Down Strata CTX/Strata DK
Strata DK Systems
Note The following instructions are based on the Stratagy IVP8 being installed in a
To the Strata DK processor, the Stratagy IVP8 functions as an analog card (RSTU). Although there are some special program settings required for the Stratagy IVP8 (e.g., DSS/BLF feature), the Strata DK should be programmed just as it would for any external voice mail system that is to be connected to it.
Important! The Strata DK may need to be reset to initialize some Strata programming assignments. It is important that you make all such assignments before installing the Stratagy IVP8.
1.Using Program
•Set code 31 for the slot where Stratagy IVP8 is installed (see Step 4: “Install Stratagy IVP8” on page 12).
•Enable the Strata DK to receive DTMF signalling from the Stratagy IVP8:
•For DK424i/DK424/DK280: Set codes 92, 93, or 94 for slot 00 for the RRCS installed on the RCTU.
•For DK40i/DK40/DK16e/DK16: Set code 92 for slot 00 for the K5RCU, K5RCU2, or K4RCU3.
•For DK24, DK56, DK96: Set codes 92 and 93 for CRCU.
•Set code 64 for the slot where the PDKU resides. Stratagy IVP8 monitors this slot for the DSS/Busy Lamp feature (see “Busy Station Identification” on page 7).
Note For DK40/DK16e/DK16: slot 11 in the Base Cabinet must be set for code 64.
•If SMDI is desired with the Strata DK424i/DK424/DK280: Set PIOU/PIOUS/RSSU for code 43 or RSIU/RSIS for code 49 to enable the SMDI port (see Program 76 if installing RSIU or RSIS SMDI port).
2.Program the Strata DK system for voice mail integration. See the Strata DK Programming Manual for details.
Step 3: Shut Down Strata CTX/Strata DK
➤Turn off the main power switch to the Strata CTX/Strata DK system.
Stratagy IVP8 Installation Guide 01/02 | 11 |
