Turbo Chef Technologies 3240 manual The Config Mode, Smart Card Screen, Updating the Firmware

Models: 3240

1 92
Download 92 pages 62.2 Kb
Page 33
Image 33
The Config Mode

The Config Mode

The CONFIG MODE (Figure 9) serves four main purposes:

1.To access the smart card screen.

2.To access the fault count screen.

3.To access the SETUP MODE.

4.To access the TEST MODE.

To access the CONFIG MODE, press the up key

from the OVEN OFF MODE.

Smart Card Screen

The smart card screen allows the user to -Load a menu from smart card to oven. -Save a menu from oven to smart card.

To load or save a menu,

1.Press L3 (Figure 9) to access the smart card screen (Figure 10).

2.Insert a smart card into the smart card slot (Figures 11 and 12), with the gold chip facing the inside of the oven.

3.Load or save a menu.

-Press R1 to load a menu from the smart card to the oven (Figure 10).

-Press R2 to save a menu from the oven to the smart card (Figure 10).

Updating the Firmware

From the oven off screen,

1.Insert the gray smart card (see Figure 11) with the gold chip facing the inside of the oven. If multiple smart cards are required, they will be labeled in sequence - ensure the correct sequence is followed.

2.From the COOLING DOWN or OVEN OFF

MODE, press and hold the idle key until the oven resets (approximately 5 seconds). The display will go blank until the upload is complete.

3.When the oven beeps one long high tone, the load was successful. If a second card was provided, insert it.

4.When the oven restarts and the display turns on, the update is complete. Remove the smart card.

NOTE: If the update is unsuccessful, the display will remain off and the oven will beep one long, low tone. If this occurs, repeat the above procedure. If the update fails multiple times, a smart card may be damaged. Contact TurboChef to obtain a new smart card.

1 5

L1

SETUP

FAULTS

R1

 

 

 

L2

CONFIG MENU

R2

 

 

 

 

 

 

 

 

L3

SMARTCARD

TEST MODE

R3

 

 

 

 

 

 

 

 

Figure 9: Config Mode

 

 

Figure 11 Smart Card slot location

 

L1

 

LOAD FROM CARD

R1

L1

INSERT SMART CARD

R1

 

SMARTCARD

 

 

 

L2

R2

L2

 

R2

 

SAVE TO CARD

 

L3

 

 

R3

L3

PRESS [BACK] TO EXIT

R3

OVEN MODES

Figure 10: Smart Card Screen

Figure 12: Insert Smart Card Screen

 

 

Page 33
Image 33
Turbo Chef Technologies 3240 manual The Config Mode, Smart Card Screen, Updating the Firmware