Turbo Chef Technologies 3240 manual Remove and Clean the Conveyor requires TWO people

Step 7

Step 8

Step 9

Right

Left

Step 10

Step 11

Step 7: Remove and Clean the Conveyor (requires TWO people)

-Position one person at each end of the conveyor.

-Lift the conveyor assembly up and then towards the left side of the oven until the conveyor drive chain has enough slack for removal.

-Remove the conveyor drive chain.

WARNING: Never attempt to remove the conveyor with fewer than 2 people.

-Lift the conveyor and push it through the right side of the oven for removal. -Wash, rinse, and dry the conveyor with a clean towel.

Step 8: Remove and Clean the Lower End Panels

-Remove both lower end panels from each end of the oven.

-Wash and rinse the lower end panels, then dry them with a clean towel.

Step 9: Remove and Clean the Upper Nozzle Plate

-Remove the thumbscrew holding the upper nozzle plate in place on the right side -of the oven (located between the two handles). If the right side upper air diverter is -incorrectly positioned in front of the lip of the upper nozzle plate, remove the right -side upper air diverter.

-Spray the upper nozzle plate with TurboChef Oven Cleaner to break apart any -heavy stains. Allow cleaner to penetrate stains for five minutes.

-Scrub the upper nozzle plate with a nylon scrub pad.

-Rinse the upper nozzle plate with water and wipe it with a clean, damp towel.

WARNING: Be sure to THOROUGHLY remove all cleaner residue.

Step 10: Remove and Clean the Right and Left Lower Air Diverters

-Remove the four thumbscrews from the right side lower air diverter. -Remove the right side lower air diverter.

-Remove the two thumbscrews from the left side lower air diverter. -Remove the left side lower air diverter.

-Wash and rinse the lower air diverters, then dry them with a clean towel.

Step 11: Remove and Clean the Lower Plenum Assembly

-Remove the lower plenum assembly from the right side of the oven.

-Spray the lower plenum assembly with TurboChef Oven Cleaner to break -apart any heavy stains. Allow cleaner to penetrate stains for five minutes. -Scrub the lower plenum assembly with a nylon scrub pad.

-Rinse the lower plenum assembly with water and wipe it with a clean, damp towel. WARNING: Be sure to THOROUGHLY remove all cleaner residue.

7

C L E A N I N G