Turbo Chef Technologies 3240 Accessing the Burner Control Screen, Viewing the Status Indicators

1 8 OVEN MODES

Accessing the Burner Control Screen	2.	Press the up or down keys to change the
From screen 1 of the TEST MODE (Figure 18,		speed of the selected blower in 5%
		increments. The percentage of air cannot go
page 17), press L1 to access the burner control
		below 30% or above 100%.
screen (Figure 21).
Use this mode to set gas pressures (see page 3).	Viewing the Status Indicators
To change the burner’s setting,	Figure 21
-Press L1 to set the burner to full (or to	The status indicators are located at the bottom
-light the burner).	of TEST MODE screen 1 and the burner control
-Press L2 to set the burner to low.	screen. The status indicators are split into two
	display lines.
-Press R1 to turn the burner off.
Accessing the Belt Control Screen	Top Display Line
	The top display line shows values relating to
From TEST MODE screen 1 (Figure 18, page 17),
	oven components. The letters a-g below and on
press L2 to access the belt control screen (Figure	Figure 23 indicate the different top display line
22). Use this mode to verify the belts work cor-	status indicators, which are explained below.
rectly. The number after the belt speed shows	a	Shows which key is currently pressed.
the pulses read by the HES. The percentage is
		-U = up key
the amount of drive being asked of the CMSC
		-D = down key
(100% = 10V).
		-a	= L1
To change the belt’s setting,		-b	= L2
		-c	= L3
-Press L1 to turn the belts off.
		-f	= R1
-Press L2 to access the belt F controls.
		-g	= R2
-Press L3 to access the belt R controls.		-h	= R3
		-P	= back/off key
Manipulating the Top and Bottom		-I	= idle key

Blowers

-S = emergency stop key

Figure 18, page 17.

The user can change the speed of the top and bottom blowers independently. To change the speed of the blowers,

1.From screen 1 of the TEST MODE, press R1 to access the top blower or R2 to access the bottom blower.

bShows the temperature within the electrical compartment (temperature displayed in Celsius only).

cShows the temperature within the cook chamber.

dShows the % value to which the gas valve is set.

L1

L2

L3

BURN FULL (LIGHT)BURN OFF

BURNER CTRL

BURN LOW	TCC = 475F
D EC27 450F	45%	100%	23.9V	0.0V

R12_H____–––––___O__TBTB–F––––

R1

R2

R3

BELTS OFF

BELT F BELT CTRL

10:25 1920 36%

BELT R
12:30	1343 31%

Figure 21: Burner Control Screen Figure 22: Belt Control Screen