Turbo Chef Technologies HHB-8085, HHB-8136, HHB-8029, HHB-8028, HHB-8134 Swing Arm Assembly Figure

56 THE IMPINGEMENT CIRCUIT

Swing Arm Assembly (Figure 58)

The Swing Arm Assembly is actuated by the Rack Oscillator Motor. The attached oven rack oscillates when the Swing Arm Assembly is in motion.

If the rack is not oscillating properly,

1.Ensure “Cool Down” process is completed. (“Cool Down” message will disappear upon completion.)

2.Ensure recipe settings have the rack set at “ON.” (See pages 12-14 for modifying recipes.)

3.If recipe settings are correct, ensure the Rack Oscillator Motor is working properly (page 41).

4.If problem persists, use the figure below to trou- bleshoot the Swing Arm Assembly.

5.Unplug the oven.

6.Remove all components from the left and right sides of the oven (including insulation) to access the Swing Arm Assemblies.

7.Remove the Swing Arm Covers.

8.Correct problem and reinstall all components.

88

89

87

86

NOTE: Some oven components have been removed for clarity.

NUMBER	PART	PART NUMBER
86	Drag Link – Swing Arm Assembly	HHB-8044
87	Swing Arm Assembly with Link Bar	HHB-8050
88	Bushing – Swing Arm Assembly (x2)	100152
89	Swing Arm Assembly	HHB-8040

 : Swing Arm Assembly