U-Line CLR2160, 2275DWRWS Service and Repair, Minor Adjustment, Severe Adjustment, 3-51, Figure

Models: 2175R 2115R 2115WC 2175/2275DWRR 2115WCOL 2175BEV 2175WC 2175RF CLR2160 CO2175/CO2275DWR CO2175F CLRCO2175 2275DWRWOL 2175WCOL 2275DWRWS

1 180
Download 180 pages 38.87 Kb
Page 66
Image 66
SIDE-TO-SIDE ADJUSTMENT

Section 3 - Service and Repair

SIDE-TO-SIDE ADJUSTMENT

See Figure 46. The drawer will need a side-to-side adjustment if, when viewed from the top, the drawer front is not square with the sides of the cabinet. This is caused by one of the slides being mounted too far forward on the unit’s liner.

Not Aligned Side-to-Side Minor Adjustment

Top View of Unit

ULIN_0315_A

Figure 46

Minor Adjustment

NOTE: The mounting holes on the slide are slightly larger than the screws’ diameter.

1.Loosen the slide’s mounting screws.

2.Push the slide backward.

3.Retighten the screws (Figure 47).

Loosen

Mounting Screws

Push Slide

Backward

ULIN_0316_A

Figure 47

Severe Adjustment

NOTE: The slides have extra mounting holes that may be used.

1.Remove the slide’s mounting screws.

2.Reposition the slide so it is the same distance from the front of the liner as the other slide. Measure to confirm.

3.Mark new drilling holes using different sets of mounting holes on the slide (Figure 48).

Mark and Drill New

Mounting Holes

Push Slide

Backward

ULIN_0318_A

Figure 48

NOTE: Front location holes are shown. Corresponding rear holes will also need to be marked.

4.Drill all the new holes with a #30 drill bit.

5.Remount the slide.

FRONT-TO-BACK ADJUSTMENT

See Figure 49. The drawer will need a front-to-back adjustment if, when viewed from the side, the drawer front is cocked forward or back. This is caused by the slide mountings not being level front to back.

Severe AdjustmentFRONT-TO-BACK ADJUSTMENT3-51 Not Aligned Front-to-Back

Side View of Unit

ULIN_0319_A

Figure 49

Minor Adjustment

NOTE: The mounting holes on the slide are slightly larger than the screws’ diameter.

1.Loosen one slide’s mounting screws.

2.Level the slide.

3.Retighten the screws (Figure 50).

3-51

Page 66
Image 66
U-Line CLR2160, 2275DWRWS Service and Repair, Minor Adjustment, Severe Adjustment, 3-51, Side-To-Sideadjustment, Figure