U-Line CO2175/CO2275DWR, 2275DWRWS Service and Repair, 3-50, Checking Drawer Alignment, Figure

Models: 2175R 2115R 2115WC 2175/2275DWRR 2115WCOL 2175BEV 2175WC 2175RF CLR2160 CO2175/CO2275DWR CO2175F CLRCO2175 2275DWRWOL 2175WCOL 2275DWRWS

1 180
Download 180 pages 38.87 Kb
Page 65
Image 65
CHECKING DRAWER ALIGNMENT

Section 3 - Service and Repair

CHECKING DRAWER ALIGNMENT

The unit’s drawers are aligned at the factory before shipment. However, their alignment could have been disturbed during shipment or during overlay panel installation.

 

Aligned

 

Front-to-Back

 

Aligned

 

Side-to-Side

Aligned

 

Top-to-Bottom

ULIN_0312_A

Figure 44

See Figure 44. Check each drawer to confirm that it is aligned:

Side-to-Side— When viewed from the top, the drawer front should be square with the sides of the cabinet.

Front-to-Back— When viewed from the side, the drawer front should be straight with the cabinet’s sides, not cocked forward or back.

Top-to-Bottom— When viewed from the front, the drawer should be level horizontally.

If both drawers are properly aligned, no further adjustment is necessary. If either drawer is not aligned, carefully follow instructions to remove that drawer, make the necessary adjustment and re-install the drawer.

ADJUSTING DRAWER ALIGNMENT

ADJUSTING DRAWER ALIGNMENTWARNING

SHOCK HAZARD — The unit must be unplugged from the wall outlet during drawer removal, adjustment and re-installation.

DRAWER REMOVAL

1.Confirm that the unit is unplugged from wall outlet.

2.Unplug the drawer’s connection wiring (top drawer only).

3. Remove the mounting screws (Figure 45 and Figure 46).

Mounting

Screw

ULIN_0313_A

Figure 45

4. Pull the drawer completely out of the unit.

DRAWER REMOVALCAUTION

Use care when handling the drawer. Drawer edges, drawer rail and the unit’s slide may be sharp.

IMPORTANT

Drawer adjustments are made by moving the slide that carries the drawer’s rail. Minor adjustments may be made by loosening one of the slide’s mounting screws, adjusting the slide and retightening the screw. Severe adjustments may be made by removing the slides’ mounting screws, drilling new mounting holes and remounting the slide.

3-50

Page 65
Image 65
U-Line CO2175/CO2275DWR, 2275DWRWS Service and Repair, 3-50, Checking Drawer Alignment, Figure, Adjusting Drawer Alignment