U-Line 2175RF, 2275DWRWS Service and Repair, Severe Adjustment, Minor Adjustment, 3-52, Figure

Models: 2175R 2115R 2115WC 2175/2275DWRR 2115WCOL 2175BEV 2175WC 2175RF CLR2160 CO2175/CO2275DWR CO2175F CLRCO2175 2275DWRWOL 2175WCOL 2275DWRWS

1 180
Download 180 pages 38.87 Kb
Page 67
Image 67
TOP-TO-BOTTOM (AND LEFT-TO-RIGHT) ADJUSTMENT

Section 3 - Service and Repair

Screws Should

Be Loose

Level the Slide

ULIN_0320_A

Figure 50

4.Repeat the procedure for the other slide.

Severe Adjustment

NOTE: The slides have extra mounting holes that may be used.

1.Loosen one slide’s rear mounting screws.

2.Remove the slide’s front mounting screws.

3.Reposition the slide so it is level.

4.Mark new front drilling holes using a different set of mounting holes on the slide (Figure 51).

Mark and Drill New

Mounting Holes

Level the Slide

ULIN_0322_A

Figure 51

5.Drill the new holes with a #30 drill bit.

6.Remount the slide.

7.Repeat procedure for the other slide.

TOP-TO-BOTTOM (AND LEFT-TO-RIGHT) ADJUSTMENT

Not Aligned Top-to-Bottom

 

 

Not Aligned Left-to-Right

 

Top View of Unit

Front View of Unit

ULIN_0323_A

Figure 52

See Figure 52. The drawer will need a top-to-bottom adjustment if, when viewed from the front, the drawer is not level horizontally. Viewed from the top, one side will protrude. This is caused by one of the slides being mounted higher than the other slide on the unit’s liner.

Minor Adjustment

NOTE: The mounting holes on the slide are slightly larger than the screws’ diameter.

1.Loosen one slide’s mounting screws.

2.Push the slide upward or downward to match the position of the other slide.

3.Retighten the screws (Figure 53).

Loosen

Mounting Screws

Push Slide 3-52

Manual background Upward or

Downward Manual background

ULIN_0324_A

Figure 53

4.Repeat the procedure with the other slide if necessary.

Severe Adjustment

NOTE: The slides have extra mounting holes that may be used.

1.Remove one slide’s mounting screws.

2.Reposition the slide so it is the same distance from the bottom of the liner as the other slide. Measure to confirm.

3.Mark new drilling holes using different sets of mounting holes on the slide (Figure 54).

3-52

Page 67
Image 67
U-Line 2175RF, 2275DWRWS, 2175WCOL, 2275DWRWOL, CO2175F Service and Repair, Severe Adjustment, Minor Adjustment, 3-52, Figure