U-Line 2175R, 2275DWRWS, 2175WCOL, 2275DWRWOL, CLRCO2175, CO2175F, CO2175/CO2275DWR Troubleshooting

				Section 2 - Troubleshooting
		Cause		Remedy
Low ice production.
1.	Control set too cold.		1.	Adjust control warmer.
2.	Fan motor stalled.		2.	Replace fan motor.
3.	Ice cubes too large.		3.	Lower water fill adjustment.
4.	Dirty condenser.		4.	Clean condenser.
5.	Bypass valve stuck open (Frost Free units only).		5.	Replace bypass valve (Frost Free units only).
Not freezing (compressor and fan motors
operating).
1.	Little or no frost pattern on evaporator.		1.	Check for sealed system leak or restriction.
2.	Bypass valve stuck open (Frost Free units only).		2.	Replace bypass valve (Frost Free units only).
Not freezing (compressor not operating - fans
operating).
1.	Relay inoperable.		1.	Replace relay.
2.	Overload inoperable (open).		2.	Replace overload.
3.	Compressor inoperable.		3.	Replace compressor.
Not freezing (compressor and fans not operating).
1.	Power cord not plugged in.		1.	Plug in power cord.
2.	Unit turned off.
			2.	Press On/Off button to turn unit on.
3.	Control panel inoperable.
			3.	Replace control panel.
4.	Hold switch inoperable (open).
			4.	Replace hold switch.
5.	Control inoperable.
			5.	Replace control.
6.	Broken wire in freeze circuit.
			6.	Repair or replace wiring.
7.	Ejector blades not in freeze position (12:00)
			7.	Manually advance ejector blades to the 12:00 position (test ice
				maker and limit switch).
Compressor overheating.
1.	Condenser air flow restricted.		1.	Remove restriction (clean condenser and grille).
2.	Condenser fan blade obstructed.		2.	Remove blade restriction.
3.	Condenser fan motor stalled.		3.	Replace fan motor.
4.	Compressor inoperable.		4.	Replace compressor.
Compressor will not stop operating.
1.	Temperature set too cold.		1.	Adjust temperature warmer.
2.	Control inoperable.		2.	Replace control.
3.	Control sensing bulb not sensing mold		3.	Fully insert bulb into ice maker tube. Rout bulb away from
	temperature.			compressor discharge tube.
4.	Evaporator fan stalled.		4.	Remove obstruction or replace motor.

2-5