U-Line CLRCO2175, 2275DWRWS, 2175WCOL Adjusting Door Alignment, Notch must face center of door

Section 3 - Service and Repair

NOTE: If door is adjusted correctly, but panel is not square with the adjacent cabinets, slight adjustments can be made by drilling the holes in the vinyl-coated steel panel slightly oversized (Figure 37).

1"± 1/32"

Rear View

of

Wood Panel

1"± 1/32"

Drill 5/32" x 3/8" Deep for use with #10 x 5/8" Wood Screw and Nylon Spacer – 6 Places

27"± 1/4"

14-5/16"±1/4"

1"± 1/8"

ULIN_0310_A

Figure 37

ADJUSTING DOOR ALIGNMENT

1.Remove top hinge screw pin using a Phillips screwdriver (Figure 38). Remove door by tilting forward and lifting off bottom hinge pin.

ULIN_0133_A

Figure 38

2.With door upside-down, loosen but do not remove the two screws on the door’s bottom hinge plate.

Slotted
Mounting	Notch must face center of door
Holes
Raise	Lower
Outside	Outside
Door Edge	Door Edge
	ULIN_0297_A

Figure 39

3.See Figure 39 and Figure 40. If the top far edge of the door needs to move UP, move the hinge plate toward the outside of the door and retighten screws. If the top far edge of the door needs to move DOWN, move the hinge plate toward the inside of the door and retighten screws.

Slotted
Mounting
Holes	Angled Edge
	Towards Center
	of Door
Raise	Lower
Outside	Outside
Door Edge	Door Edge
2115WC, 2115WCOL, 2175WC, 2175WCOL Only
	ULIN_0311_A

Figure 40

4.Mount the door to recheck alignment and repeat steps 2 and 3 if further adjustment is necessary.

5.When top edge of door is parallel to top edge of cabinet, remove the door and ensure the two screws are secure.

6.Remove the door closers from the bottom hinge, clean thoroughly and lubricate the mating surfaces with petroleum jelly.

7.Reinstall the closers, lining up the bosses with holes in hinge and hinge plate (Figure 41).

3-48