Vanguard Managed Solutions 342 installation manual Features and Functionality

		Features and Functionality
Features and Functionality
Introduction
	This section describes the features available with your Vanguard 342 device. For
	descriptions of the software running on your Vanguard 342, refer to the appropriate
	protocol document. These documents can be found on the VanguardMS Web site:
	http://www.vanguardms/documentation/
Standard Features The standard Vanguard 342 provides these features:
	• Low Profile enclosure with rear accessible motherboard, and support for two
		Vanguard Daughtercards
	• Motorola MPC860P PowerPC processor
	• 8 Megabytes of Non-Volatile FLASH on board
	• 8 Megabytes FLASH SIMM (optional)
	• 32 Megabytes of SDRAM DIMM
	• Standard rear panel ports include:
		- Two daughtercard ports
		- One serial interface DB25 port supporting V.24, V.35, V.36, V.11/X.21
		interfaces
		- One Async (RJ-45 connector) Control Terminal Port (CTP) for local and
		remote configuration, and management
		- Two 10/100BaseT Ethernet port with auto-sensing
	• Data Encryption & compression SIMM slot (optional)
	•	ECC DIMM slot
	•	External power supply
10/100BaseT
	Ports 5 and 8 are 10/100BaseT Ethernet and conform to the Fast Ethernet
Ethernet Cable	specification (IEE 802.3u) known as 100BaseT. This LAN standard has raised the
	Ethernet speed limit from 10 Megabits to 100 Megabits per second. This Ethernet
	port has an auto-sensing feature that allows it to determine if the connection is
	10BaseT or 100BaseT and adjust its speed as required.
Control Terminal
	Port 4 can be used as a Control Terminal Port (CTP) for configuration, reporting, and
Port (CTP)	troubleshooting the Vanguard 342.
	To access the CTP you must also configure your terminal or terminal emulation
	software, to VT100, 9600 bps, 8 bit, no parity, 1 stop bit.

Dual Daughtercard The Vanguard 342 comes with two slots to support optional daughtercards. This

Slots permits easy future expansion of the product.

About the Vanguard 342 1-3