Vanguard Managed Solutions 342 Powering Up Your Vanguard, Powering On, Resetting

Powering Up Your Vanguard 342

Powering Up Your Vanguard 342

Introduction	This section describes the sequence of events when you power up and power down
	the Vanguard 342.
Powering On the
	The Vanguard 342 does not have a power switch on the unit. Use these steps to
Vanguard 342	power on the device:
	1) Plug the DC output cable of the power supply into the power socket on the
	Vanguard 342 back panel.
	2) Connect the power cord to the power supply outlet.
Resetting the 342
	The RESET button resets the node. Pressing the RESET button is the equivalent of a
	power-up operation which clears all existing calls and brings down all links.
	For the location of the RESET button, refer to the “Enclosure” section in Chapter 2.

4-2 Powering Up and Loading Software