ViewSonic pjl9371 manual OPTION menu, Description, Auto Search, Keystone, Direct On, ViewSonic

OPTION menu

OPTION menu

From the OPTION menu, items shown in the table below can be performed.

Select an item using the ▲/▼ cursor buttons, and press the ► cursor (or the ENTER) button to execute the item, except for the items LAMP TIME and FILTER TIME. Then perform it according to the following table.

Item

Description

	Using the ▲/▼ cursor buttons turns on/off the automatic signal
	search function.
	ON  OFF
AUTO SEARCH	When the ON is selected, detecting no signal automatically cycles
	through input ports in the following order. The search is started from
	the current port. Then when an input is found, the projector will stop
	searching and display the image.
	COMPUTER IN1  COMPUTER IN2
	VIDEO ï S-VIDEO ï COMPONENT (Y, Cb/Cr, Cr/Pr)
	Using the ▲/▼ cursor buttons turns on/off the automatic keystone
	function.
	ON  OFF
	ON : Automatic keystone distortion correction will be executed
AUTO	whenever changing the slant of the projector.
	OFF : This function is disabled. Please execute the AUTO
KEYSTONE	KEYSTONE (EXECUTE) in the SETUP menu for automatic
	keystone distortion correction.
	• When the projector is suspended from the ceiling this feature will
	not function properly so select the OFF.
	• This function will be unavailable when the Transition Detector is
	on.
	Using the ▲/▼ cursor buttons turns on/off the DIRECT ON function.
	ON  OFF
	When set to the ON, the lamp in projector will be automatically
	turned on without the usual procedure, only when the projector is
DIRECT ON	supplied with the power after the power was cut while the lamp was
	on.
	• This function does not work as long as the power has been
	supplied to the projector while the lamp is off.
	• After turning the lamp on by the DIRECT ON function, if neither
	input nor operation is detected for about 30 minutes, the projector is
	turned off, even though the AUTO OFF function is disabled.

(continued on next page)

ViewSonic 42 PJL9371