Master Sub Relationship

Master/Substation associations are set up by using station #200 as the programming station. Once these relationships have been established, substations can then contact their designated master stations by simply touch dialing

If TL-600S Handset substation is used, substations can be connected to their designated master stations by simply picking up a handset. (Only applicable to system)

With respect to this function, the stations in the system are divided into two categories; master stations and substations. Any master station can be connected to any other station in the system. However, substations can initiate calls only to specific master stations. This is done by single touch dialing, and will only connect the substation to one specific master.

Several substations can be programmed under this station to connect with a single specified master station.

To register single digit dialing, touch dial

substation number

Single digit dialing from that master to a specific substation is then accomplished by touch dialing

Programming a master station for Single Digit Dialing of a substation number under this function is programmed in

the same manner as other single digit dialing, and results in one touch dialing from master to substation.

Note.

Single digit registration is not available from any substa-

tion programmed by No.200 programming, even if its

line is connected with master station.

Substation

Master Station

Handset substation

Only applicable to

system

Single Digit Registration of Substation

Master Station

Substation Number

Substation

Automatic Access To Paging

Once programming has been set up for the purpose of this function.

A paging call may be made from specific Handset Sub- stations to the registered zone by simply picking up a handset. Refer to Fig. 1

A specific Handset substations may respond to the paging call by simply picking up a handset. Refer to Fig. 2

Note.

Single digit registration for Handset Substation as well as No.200 programming is required for this function at

the time of installation.

NP Type

Paging call

Fig. 1

Paging call

Paging response

Response to

a paging call

Fig. 2

– 27 –

Page 30
Image 30
Vizio EXES-6000 CP-64 Master Sub Relationship, Automatic Access To Paging, Line is connected with master station