Instrument Specific Scpi Commands, Normal

www.vxitech.com

TABLE 4-2: INSTRUMENT SPECIFIC SCPI COMMANDS

Command	Description	RST	RST Value
FETCh:CONDitioned?	Reads back the 16-bit value that
	represents the current conditioned
	(masked and inverted) output state of
	the comparators in the group.
FETCh:LATChed?	Read back the 16-bit value that was
	latched when the first input(s) in the
	group caused an active edge.
FETCh:RAW?	Reads back the 16-bit value that
	represents the current unconditioned
	(no masking or inversion) output state
	of the comparators in the group.
INHOUSE:PSEUDO	Sets the type of register interface used.
INHOUSE:REGINT	Controls type of interrupt response	X	0
INHOUSE:REG_ENABLE	Interrupt masking	X	0
INHOUSE:CLEAR_LATCH	Controls clearing of first latched	X	0
	information.
INPut:DEBounce	This sets the debounce timing on a	X	19.2 ∝s
	group of the analog comparators.
INPut:MASK	Sets the masking for a group of	X	0
	channels
INPut:MASK:INTerrupt	Enable or disable interrupt generation	X	0
	when changing MASKs
INPut:OFFSet	Sets the comparator threshold for a	X	0.469 V
	group of channels.
INPut:POLarity	Sets the polarity for a group of	X	NORMAL
	channels.
INPut:RANGe	Sets the range for a group of channels.	X	100
OUTPut:POLarity:EXTernal:INTerrupt	Sets the polarity for the interrupt	X	NORMAL
	output on the front panel for one of the
	three groups.
OUTPut:POLarity:EXTernal:LATChed	Sets the polarity for latched interrupt	X	NORMAL
	output on the front panel for one of the
	three groups.

VM4016 Command Dictionary