VXI Technology, Inc.
INHOUSE:REG_ENABLE
The INHOUSE:REG_ENABLE command controls the masking for REGINT. REG_ENABLE 0 means that backplane interrupts cannot be generated. If the REG_ENABLE is 1, then backplane interrupts can be generated. If PSEUDO is set, then a write to the register at offset 0x38 also controls the masking. Enable or disable capabilities are provided in the pseudo register interface to allow a complete register interface. It is important to note that all letters of the command must be provided as there is no short form for this command.
INHOUSE:REG_ENABLE <boolean> | Where <boolean> is 0 OFF 1 ON. |
|
|
EXAMPLES |
|
INHOUSE:REG_ENABLE 1 | Enables the REGINT type interrupt |
| generation |
INHOUSE:REG_ENABLE? | Returns 1 to state that backplane |
1 | interrupting is currently enabled. |
INHOUSE:REG_ENABLE 0 | Disabling REGINT interrupt generation. |
INHOUSE:REG_ENABLE? | Returns 0 to state that backplane |
0 | interrupting is currently disabled. |
24 | VM4016 Programming |
