Wayne-Dalton 9100, 9400, 9600 installation instructions Top Section, Installation

11	Top Section
Tools Needed:	Place the top section in the opening	door width
	and vertically align with lower sections.
Hammer		+3-3/8” to 3-1/2”
Tape Measure	Temporarily secure the top section by
	driving a nail in the header near the
Power Drill	center of the door and bending it over
	the top section.
7/16” Socket
Driver	Now flip up hinge leaf against section,
	fastening center hinges first, and end
	hinges last. (Refer to Step 6).

When installing a door with a torsion counterbalance system, vertical track alignment is critical. Position flagangle between 1-11/16” (43 mm) to 1-3/4” (44 mm) from the edge of the door. Tighten the bottom lag screw. Flagangles must be parallel to the door sections.

Repeat for opposite side.

IMPORTANT: THE DIMENSION
BETWEEN THE FLAGANGLES MUST BE
DOOR WIDTH PLUS 3-3/8” (86MM) TO
3-1/2” (89 MM) FOR SMOOTH, SAFE	NAIL		vERTICAL tRACK
DOOR OPERATION.
Complete the vertical track installation
by securing the center jamb bracket(s)			ROLLER
and tightening the other lag screws.
Push the vertical track against the
rollers so that the rollers are touching
the deepest part of the curved side of
the track (see illustration). Tighten all		top section	ROLLER Against
the carriage bolts and nuts.
			VERTICAL TRACK
Repeat for opposite side.
			1-11/16” TO 1-3/4”

FLAGANGLE

top

SECTION

19

INSTALLATION

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com