Wayne-Dalton 9600, 9400, 9100 installation instructions Step Plate, optional INSTALLATION

	Step Plate
Tools Needed:	Make one mark 1” (25 mm) up from
7/16” Drill Bit	the center of bottom edge of the bottom
	section and another mark 2-3/16” (56
Power Drill
	mm) up from the first mark.
7/16” Wrench	Drill a 7/16” (11 mm) hole through the
	section at each mark and insert the
	outside step plate.
	Loosely fasten step plate slide to base
	with (1) 1/4” - 20 x 5/8” carriage bolt
	and nut.
	Align inside step plate holes and
	fasten from inside using the #8 screws
	provided. Install one #8 x 3/4” screw in
	the bottom step plate hole. The screw in
	the top hole varies with door models.
	Use the screw size shown below for
	your model door.
	a) #8 x 3/4” screw for Model 9100
	b) #8 x 1” screw Model 9600
	Tighten 1/4”-20 carriage bolt and nut.

STEP PLATE OUTSIDE

step plate

base

1/4” - 20 x 5/8” carriage bolt

step plate
slide	hex nut
STEP PLATE INSIDE

Assembled	#8 screws
Step Plate

29

optional INSTALLATION

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com