Wayne-Dalton 9600, 9400, 9100 Rear Support, Keep horizontal track, parallel and within 3/4”, death

21	Rear Support
Tools Needed:	WARNING
Ratchet Wrench	Keep horizontal track
1/2” Socket	parallel and within 3/4”
	maximum of door edge,
1/2” Wrench	otherwise door could fall,
	resulting in severe injury or
(2) Vice Clamps	death.
	Raise the door until the top section and
	half of the next section are in a horizontal
	position. Do not raise door any further
	since rear of horizontal track is not yet
	supported.

WARNING

Raising door further can result in door falling and cause severe injury or death.

Clamp a pair of vice clamps on the vertical tracks just above the second roller on one side, just below the second roller on the other side. This will prevent the door from raising or lowering while installing the rear support.

Using perforated angle, 5/16” x 1-5/8” hex head lag screws and 5/16” bolts with nuts (may not be supplied), fabricate rear support for horizontal tracks. Attach horizontal tracks to the rear supports with 5/16”- 18 x 1-1/4” hex bolts and nuts (may not be supplied). Horizontal tracks must be level and parallel with door.

NOTE: If rear supports are to be installed over drywall, use 5/16” x 2” hex head lag screws.

Adjust weather seal (if necessary) Now permanently attach the weather seal to both door jambs and header. (Temporarily attached in PREPARING THE OPENING on page 10.) Avoid pushing weather seal stop too tightly against face of door.

DOOR IN THE

UP POSITION

vice clamps

vertical

TRACK

Door Edge

3/4”

Horizontal Track

26

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com