Wayne-Dalton 9600, 9400, 9100 installation instructions Trolley Operator

Trolley Operator

Tools Needed: WARNING

OPERATOR MUST BE TESTED

AT TIME OF INSTALLATION AND

MONTHLY THEREAFTER TO

ENSURE THAT DOOR REVERSES

ON CONTACT WITH 2 X 4 BOARD

LAID FLAT UNDER THE DOOR.

FAILURE TO ADJUST OPERATOR,

IF NECESSARY, CAN RESULT IN

SEVERE OR FATAL INJURY. IF

YOUR OPERATOR IS EQUIPPED

WITH A PHOTOELECTRIC EYE

SYSTEM, THEN THIS MUST

BE TESTED AT THE SAME

TIME TO ENSURE THAT DOOR

DOES NOT CLOSE AND A

CLOSING DOOR OPENS IF

PHOTOELECTRIC EYE SYSTEM IS

OBSTRUCTED. FAILURE TO MAKE

ADJUSTMENTS, IF NECESSARY,

CAN RESULT IN SEVERE OR FATAL

INJURY.

1.Install operator rail 1/2” to 1-1/2” (13 - 38 mm) above high arc of top section of the door.

2.Mount operator to ceiling so that 1” to 1-1/2” (25 - 38 mm) clearance is maintained between trolley rail and top section when door is fully open (trolley rail will slope down towards rear).

3.Attach door arm to operator bracket installed in Step 10.

4.Attach operator rail to suitable mounting surface, 2 x 6 lumber minimum.

5.Attach operator to ceiling using perforated angle.

IMPORTANT: Angles must be securely attached to sound framing member(s).

SUITABLE MOUNTING	OPERATOR RAIL
SURFACE 2 X 6
LUMBER MINIMUM

HEADER

DOOR ARM TO OPERATOR BRACKET

perforated

OPERATORangle rail

OPERATOR

FRAMING MEMBERS

PERFORATED ANGLE

32

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com