contact your network administrator for appropriate settings, and then assign parameters as described in this section.
NETWORK PARAMETERS |
| |
1. | IP Address: | (undefined) |
2. | Subnet Mask: | (undefined) |
3. | Gateway Address: | (undefined) |
4. | IP Security: | Off |
TELNET PORT PARAMETERS |
| |
11. | Port Name: | (undefined) |
12. | Supervisor Mode: | Permit |
13. | Logoff Character: | + |
14.Sequence Disconnect: Three Characters
15.Timeout Disconnect: 5 Min
16. | Response Type: | Verbose |
17. | Command Echo: | On |
18. | Accept Break: | Yes |
Enter: #<CR> to Change,
<ESC> Exit ...
Figure 5.3: Network Parameters Menu (Supervisor Mode Only)
To access the Network Parameters menu, type /N and press [Enter]. The screen shown in Figure 5.3 will be displayed. Note that the Network Parameters menu is only available in Supervisor Mode. The Network Parameters menu offers the following options:
1.IP Address: Defines the IP Address for the CMS unit. Type 1 press [Enter], and follow the instructions in the submenu. (Default = undefined).
2.Subnet Mask: Defines the Subnet Mask for the CMS unit. Type 2 press [Enter], and follow the instructions in the submenu. (Default = undefined).
3.Gateway Address: Defines the Gateway Address for the CMS unit. Type 3 press [Enter], and follow the instructions in the submenu. (Default = undefined).
4.IP Security: Sets up the IP Security feature as described in Section 5.5.5.
11.Port Name: (Up to 16 characters) Assigns a name to the Network Port. (Default = undefined).
12.Supervisor Mode: Permits or denies access to the Supervisor Mode. When enabled (Permit), and the valid Supervisor Password is entered, this port may then issue Supervisor level commands. If disabled (Deny), the port may not enter Supervisor Mode, even when the Supervisor Password is entered. (Default = Permit).
13.Logoff Character: Defines the Logoff Character for the Network Port. The Logoff Character determines the disconnect sequence that is issued at this port in order to
