Whirlpool ED25DQXDB06 manual The ice dispenser will not operate properly, Check if, Then

Models: ED25DQXDB06

1 73
Download 73 pages 22.58 Kb
Page 56
Image 56
The ice dispenser will not operate properly

The ice dispenser will not operate properly

 

Check if ...

Then ...

 

 

 

 

 

 

The freezer door is not closed completely.

Push the door firmly shut. If it will not shut all the way, see

 

 

“The doors will not close completely” later in this section.

 

 

 

 

 

 

The ice bin is not installed correctly.

Push the ice bin in all the way. If the ice bin does not go in all

 

 

the way, it may not be put in straight. Pull it out and try again.

 

 

 

 

 

 

The wrong ice has been added to the bin.

Use only cubes produced by the current ice maker. If other

 

 

cubes have been added, remove all cubes and check to see

 

 

that none have become stuck in the delivery chute.

 

 

 

 

 

 

The ice has frozen in the ice bin.

Shake the ice bin to separate cubes. If cubes do not

 

 

separate, empty bin and wait 24 hours for ice to restock.

 

 

 

 

 

 

The ice has melted around the auger (metal spiral) in

Dump the ice cubes and clean the ice bucket completely.

 

the ice bucket.

Allow 24 hours for the ice maker to re-stock. Do not try to

 

 

remove the melted ice with a sharp object. You could

 

 

damage the ice bucket.

 

 

 

 

 

Ice is stuck in the delivery chute.

Clear the ice from the delivery chute with a plastic utensil.

 

 

Do not use anything sharp to remove the ice. You could

 

 

cause damage.

 

 

 

 

 

There is no ice in the bucket.

See “The ice maker is not producing ice” earlier in this

 

 

section.

 

 

 

 

 

The dispenser arm has been held in too long.

Release dispenser arm. Ice will stop dispensing when the

 

 

arm is held in too long. Wait three minutes for dispenser

 

 

motor to reset before using again. (For future use, take large

 

 

amounts of ice directly from the ice maker so that the dis-

 

 

penser arm is not held in too long.)

 

 

 

 

 

The water dispenser will not operate properly

Check if ...

Then ...

The freezer door is not closed completely.

Push the door firmly shut. If it will not shut all the way, see

 

“The doors will not close completely” later in this section.

 

 

The water tank has not filled.

The water tank needs to be filled the first time it is used.

 

Depress the water dispenser bar with a large container

 

until you draw two or three quarts (1.9 to 2.8 L) of water.

 

Discard water. (Refer to “Using the ice and water

 

dispensers” section for further instructions on filling the

 

water tank.)

 

 

The water shut-off valve is not turned on or the water

Check to be sure the water shut-off valve is turned on and

line is not connected at the source.

the water source is connected to the refrigerator. Refer to

 

the “Attaching the optional ice maker to a water supply”

 

section for directions.

 

 

The water shut-off valve is clogged or incorrectly

Refer to the “Attaching the optional ice maker to a water

installed.

supply” section. Call the Consumer Assistance Center or

 

a plumber.

 

 

There is a kink in the home water source line.

If you find or suspect a kink in the water line, call the

 

Consumer Assistance Center.

 

 

There is a water filter installed on the

First, check the filter installation instructions to ensure

refrigerator. This filter may be clogged

that the filter was installed correctly and is not clogged. If

or incorrectly installed.

installation or clogging is not a problem, call the Consumer

 

Assistance Center.

56

Page 56
Image 56
Whirlpool ED25DQXDB06 The ice dispenser will not operate properly, The water dispenser will not operate properly, Check if