Worth Data 701 RF Default RF Terminal Configuration, Using the bar code RF Terminal Setup Menu

Default RF Terminal Configuration

Parameter	Default Setting	Parameter		Default Setting
Radio Terminal ID	0	MSI Code		Disabled
RF Channel	0			check digit not transmitted
Code 39	Enabled			Plessey Code disabled
	Accumulate Mode ON			Label Code5 disabled
	stop/start chs not xmit	Code 128		Enabled
	check digit disabled			EAN/UCC 128 disabled
	Caps lock OFF
		Code 11		Disabled
2 of 5 Code	Disabled	RSS-14		Disabled
	I 2 of 5 Code disabled	Code 93		Disabled
	6 digit code length			Full ASCII disabled
	check digit disabled	Beep Tone		medium
UPC/ EAN	Enabled	Preamble		none
	UPC supps disabled	Postamble		none
	UPC-A NSC & check digit	Date Format		mm-dd-yy
	transmitted
	UPC-A NSC & check digit	Baud Rate	9600
	transmitted	Parity		none
	EAN-13 country code &	Data Bits	8
	check digit transmitted	Stop Bits	1
	EAN-13 country code &	Batteries		Alkaline default
	check digit transmitted	Speaker		Speaker Volume 5
				Headphone Volume 5
	UPC-E 1st char & check	Laser Options		none
	digit not transmitted	Shut Down Time		5 minutes
	UPC-E 1st char & check	Voice Messages	303015
	digit not transmitted	Characters		none reassigned
	EAN-8 1st char & check	Security Code		none
	digit not transmitted
	EAN-8 1st char & check	Control Keys Only		no
	digit not transmitted
Codabar	Disabled	Display of year		2 digit
	Start/Stop not transmitted	Skip opening screens		no
	CLSI format disabled	Aiming Dot		No
		Automatic Check Back		No
		Display Backlight Duration		5 seconds

*All parameters are set back to their defaults when reset using the bar coded Setup Menu, even parameters that are changed by keypad only. Shaded items are keypad access only.

Using the bar code RF Terminal Setup Menu

To use the bar coded RF Terminal Setup Menu, scan these bar codes in this order:

•Start Setup - you should hear 2 beeps

•Setup Parameter bar code (i.e. “Beep Tone”)-you should hear 2 beeps for each scan

•Number bar code that corresponds to the appropriate setting (i.e. “3” to change the Beep Tone to “high”) - you should hear 2 beeps for each scan

•End Setup-you should hear 3 beeps after END SETUP.

2-2